HIKVISION DS-3E1105P-EI 4 Port Fast Ethernet Smart POE Switch
- 4 × 10/100 Mbps PoE port,1 × 10/100 Mbps RJ45 port
- 6 KV surge protection for PoE ports.
- Total PoE Power Budget 60W
- Support 802.1Q VLAN
- Support PoE watchdog to detect and restart the cameras that do not respond
- Support STP/RSTP Loop prevention
- Support cable detection to locate failure
- Up to 300 m Long Range PoE Transmission
- 4 × 10/100 Mbps PoE port,1 × 10/100 Mbps RJ45 port
- 6 KV surge protection for PoE ports.
- Total PoE Power Budget 60W
- Support 802.1Q VLAN
- Support PoE watchdog to detect and restart the cameras that do not respond
- Support STP/RSTP Loop prevention
- Support cable detection to locate failure
- Up to 300 m Long Range PoE Transmission
Network Parameters | |
---|---|
Ports | 4 × 10/100 Mbps PoE port,1 × 10/100 Mbps RJ45 port |
MAC Address Table | 2 K |
Switching Capacity | 10 Gbps |
Packet Forwarding Rate | 7.44 Mpps |
Internal Cache | 1 Mbits |
PoE Power Supply | |
---|---|
PoE Standard | IEEE 802.3af,IEEE 802.3at |
PoE Power Pin | End-span: 1/2(-), 3/6(+) |
PoE Port | PoE: Ports 1 to 4 |
Max. Port Power | 30 W |
PoE Power Budget | 60 W |
Software Function | |
---|---|
Long Range | Ports 1to 4: up to 300 m.Long range performance may vary depend on camera model or cable condition. |
VIP Port | Ports 1to 2: data on VIP ports is preferentially forwarded when bandwidth resources are insufficient. |
Port Isolation | Ports 1to 4: port isolation mode to improve network securityPorts in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group. |
PoE Watchdog | Ports 1to 4: auto detect and restart the cameras that do not respond. |
Link Aggregation | Link aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection.Support static link aggregation.Support 1 aggregation groups. |
QoS | / |
Loop Prevention | Loop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default.Support 802.1D STP.Suppport 802.1w RSTP. |
VLAN | VLAN is used for network scale planning and network health improvement.Support 802.1Q.Configurable VLAN ID from 1-4094.Support Trunk, Access port mode.Support Max. 32 VLAN. |
HPP | Support one-click activation and remote management via Hik-Partner Pro. Functions supported:1. Display the port rate.2. Display the port bandwidth utilization rate.3. Display the PoE power usage.4. Display topology information.5. Display the alarm status.6. Restart ports and devices.7. Enable port long-rage mode.8. Remotely upgrade the device. |
System Maintenance | Support device management via web.Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses.Support Super IP, which is a fixed IP address (10.180.190.200) for direct access.Support management via Hik-Central Pro.Support remote management via Hik-Partner Pro. Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected.Supports 802.1ab LLDP for peer device discovery.Support SNMP v1/v2c for third-party management platform access.Support port mirroring for fault locating. |
Port Rate-Limiting | / |
Storm Control | / |
IGMP Snooping | / |
DHCP Snooping | / |
ACL | / |
IPSG | / |
General | |
---|---|
Shell | Metal material |
Net Weight | 0.26 kg (0.573 lb) |
Gross Weight | 0.75 kg (1.65 lb) |
Dimensions (W × H × D) | 121.1 mm × 27.6 mm × 83.1 mm (4.77'' × 1.09'' × 3.27'') |
Operating Temperature | 0 °C to 40 °C (32 °F to 104 °F) |
Storage Temperature | -40 °C to 85 °C (-40 °F to 185 °F) |
Operating Humidity | 5% to 95% (no condensation) |
Relative Humidity | 5% to 95% (no condensation) |
Power Supply | 54VDC, 1.2A |
Installation Mode | Desk-Mounted,Wall-Mounted |
Max. Power Consumption | 65 W |
Power Consumption in Idle | 0.9 W |
Surge Protection | 6 KV |
Approval | |
---|---|
EMC | CE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020) |
Safety | CB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition), CE-LVD (EN 62368-1: 2014+A11: 2017) |
Chemistry | CE-RoHS (2011/65/EU),WEEE (2012/19/EU),Reach (Regulation (EC) No.1907/2006) |
Available models:
DS-3E1105P-EI
DS-3E1105P-EI
Write Your Own Review
Brand | Description |
History | Color sit amet, consectetur adipiscing elit. In gravida pellentesque ligula, vel eleifend turpis blandit vel. Nam quis lorem ut mi mattis ullamcorper ac quis dui. Vestibulum et scelerisque ante, eu sodales mi. Nunc tincidunt tempus varius. Integer ante dolor, suscipit non faucibus a, scelerisque vitae sapien. |
-
Icon
Worldwide Delivery
DHL,FedEx,UPS,Postal
-
Icon
Support 24/7
Online 24 hours
-
Icon
Firmware upgradable
Original Firmware
-
Icon
payment method
Secure payment

Featured Product
