HIKVISION DS-3E1310P-SI(O-STD)V2 8 Port Fast Ethernet Smart POE Switch
- 8 × 100 Mbps PoE RJ45 port, 2 × gigabit combo.
- IEEE 802.3at/af standard for PoE ports.
- Network topology management, alarm push, network health monitor.
- 6 KV surge protection for PoE ports.
- AF/AT camera can reach up to 300 m in extend mode.
- 8 × 100 Mbps PoE RJ45 port, 2 × gigabit combo.
- IEEE 802.3at/af standard for PoE ports.
- Network topology management, alarm push, network health monitor.
- 6 KV surge protection for PoE ports.
- AF/AT camera can reach up to 300 m in extend mode.
| Network Parameters | |
|---|---|
| Ports | 8 × 10/100 Mbps PoE port,2 × Gigabit combo |
| MAC Address Table | 16 K |
| Switching Capacity | 9.2 Gbps |
| Packet Forwarding Rate | 6.84 Mpps |
| Internal Cache | 4 Mbits |
| PoE Power Supply | |
|---|---|
| PoE Standard | IEEE 802.3af,IEEE 802.3at |
| PoE Power Pin | 8-pin power: 1/2(-), 3/6(+), 4/5(+), 7/8(-) |
| PoE Port | PoE: Ports 1 to 8 |
| Max. Port Power | 30 W |
| PoE Power Budget | 125 W |
| Software Function | |
|---|---|
| Long Range | Ports 1to 8: up to 300 m.Long range performance may vary depend on camera model or cable condition. |
| Port Isolation | Ports 1to 8: port isolation mode to improve network security.Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group. |
| VIP Port | / |
| PoE Watchdog | Ports 1 to 8: auto detect and restart the cameras that do not respond. |
| QoS | QoS is used to allocate bandwidth to different services so as to provide end-to-end service quality assurance.Support port-based priority configuration.Support SP, WRR priority schedule mode. |
| Link Aggregation | / |
| Loop Prevention | Loop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default.Support 802.1D STP.Suppport 802.1w RSTP. |
| VLAN | VLAN is used for network scale planning and network health improvement.Support 802.1Q.Configurable VLAN ID from 1-4094.Support Trunk, Access port mode.Support Max. 4094 VLAN. |
| HPP | Support one-click activation and remote management via Hik-Partner Pro. Functions supported:1. Display the port rate.2. Display the port bandwidth utilization rate.3. Display the PoE power usage.4. Display topology information.5. Display the alarm status.6. Restart ports and devices.7. Enable port long-rage mode.8. Remotely upgrade the device. |
| System Maintenance | Support device management via web.Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses.Support Super IP, which is a fixed IP address (10.180.190.200) for direct access.Support management via Hik-Central Pro.Support remote management via Hik-Partner Pro. Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected.Supports 802.1ab LLDP for peer device discovery.Support SNMP v1/v2c for third-party management platform access.Support port mirroring for fault locating. |
| Storm Control | Storm control is used to prevent switch ports from being blocked by broadcast or multicast storms in the LAN, which may affect network communication.Supports port rate limiting based on broadcast, multicast, and unknown unicast packets. |
| DHCP Snooping | DHCP Snooping can prevent unauthorized connections to DHCP servers from disrupting the network and affecting normal network communication, and only allow DHCP packets from trusted ports to pass throughOff by default. |
| Port Rate-Limiting | / |
| IGMP Snooping | / |
| ACL | / |
| IPSG | / |
| General | |
|---|---|
| Shell | Metal material |
| Net Weight | 1.72 kg (3.79 lb) |
| Gross Weight | 2.20 kg (4.85 lb) |
| Dimensions (W × H × D) | 266.00 mm × 44.50 mm × 220.80 mm (10.47'' × 1.75'' × 8.69'') |
| Operating Temperature | 0 °C to 45 °C (0 °F to 113 °F) |
| Storage Temperature | -40 °C to 85 °C (-40 °F to 185 °F) |
| Operating Humidity | 5% to 95% (no condensation) |
| Relative Humidity | 5% to 95% (no condensation) |
| Power Supply | 100-240 VAC, 50/60 Hz, Max. 1.5 A |
| Installation Mode | Rack (equipped with mounting ears) |
| Max. Power Consumption | 150 W |
| Power Consumption in Idle | 5 W |
| Surge Protection | 6 KV |
| Approval | |
|---|---|
| EMC | FCC (47 CFR Part 15,Subpart B); CE-EMC (EN 55032: 2015,EN IEC 61000-3-2: 2019,EN 61000-3-3: 2013+A1: 2019,EN 50130-4: 2011 +A1: 2014,EN 55035: 2017); IC (ICES-003: Issue 6); RCM (ASNZS CISPR 32: 2015) |
| Safety | UL (UL 60950-1); CB (IEC 60950-1:2005,AMD1:2009,AMD2:2013,IEC 62368-1: 2014 (Second Edition); CE-LVD (EN 60950-1: 2006 + A11: 2009 +A1: 2010+A12: 2011+A2: 2013,EN 62368-1: 2014+A11: 2017) |
| Chemistry | CE-RoHS (201165EU); WEEE (201219EU); Reach (Regulation (EC) No.19072006) |
Available models:
DS-3E1310P-SI
Write Your Own Review
| Brand | Description |
| History | Color sit amet, consectetur adipiscing elit. In gravida pellentesque ligula, vel eleifend turpis blandit vel. Nam quis lorem ut mi mattis ullamcorper ac quis dui. Vestibulum et scelerisque ante, eu sodales mi. Nunc tincidunt tempus varius. Integer ante dolor, suscipit non faucibus a, scelerisque vitae sapien. |
-
Worldwide Delivery
DHL,FedEx,UPS,Postal
-
Support 24/7
Online 24 hours
-
Firmware upgradable
Original Firmware
-
payment method
Secure payment
Featured Product
